Skip to content

How To Install Belt Tensioner

There can be a lot of tension on a belt drive system, so it’s important to have a tensioner to keep the belt tight. Instructions on how to install a belt tensioner vary depending on the make and model of your car, but typically it will involve removing the old tensioner, installing the new tensioner, and then tightening the bolts.

How To Install Belt Tensioner

The belt tensioner is an important part of the engine that helps to keep the belt in place. It is important to make sure that the tensioner is installed properly and is functioning correctly. There are a few things that you can do to install the belt tensioner properly. First, you need to remove the old belt tensioner. There are usually bolts or screws that hold it in place. Once it is removed, you can install the new one. Make sure that the new

-A belt tensioner tool -Socket wrench -Wrench -Ratchet -Allen wrench -New belt

  • park the car on a level surface and put it in gear. 2. jack up the car so that the front is off the ground. 3. remove the wheel on the side of the belt tensioner

-How to install belt tensioner? -What are the things to consider in installing belt tensioner?

Frequently Asked Questions

How Do You Put On A Belt Tension?

There is not one definitive way to tension a belt. Different belts will require different amounts of tension, and the amount of tension you need may also vary depending on how you are using the belt. In general, you will want to tighten the belt enough so that it does not slip, but not so tight that it cuts into your skin or is uncomfortable to wear.

How Tight Should A Belt Tensioner Be?

There is no definitive answer to this question as it depends on the make and model of belt tensioner, as well as the specific application. In general, the tensioner should be tightened until it is slightly resisting the turning of the belt.

Is It Hard To Replace A Belt Tensioner?

It can be hard to replace a belt tensioner, particularly if the part is not easily accessible. The tensioner is responsible for ensuring that the belt remains tight against the pulleys, and therefore it is important to ensure that it is working correctly. If the tensioner is worn or damaged, it may need to be replaced.


There are a few steps in installing a belt tensioner. The first is to remove the old one, which can be done by loosening the bolts and removing the tensioner arm. The next step is to install the new tensioner, making sure to align the holes correctly. After that, it’s just a matter of tightening the bolts and putting the cover back on.

Leave a Reply

Your email address will not be published. Required fields are marked *